Browse Open Jobs

Port engine overheating after 20 min at cruising RPM. Impeller replaced last season. Need diagnosis and repair. Boat is at marina slip.

Need full winterization for twin Yamaha 150s including fogging, lower unit oil change, and fuel stabilization. Boat on trailer.

Marine generator cranks but won't start. Fuel filters changed. Suspect fuel pump or injector issue. Need diagnosis.

Looking to get a full detail of my 28ft Regulator Center Console.

T-top has cracked weld at base. Need aluminum weld repair and re-powdercoat. Canvas still intact.

Need bellows replacement, U-joint service, and gear oil change on Volvo Penta DPS outdrive. 5 years since last service.

3 bronze seacocks are frozen. Need replacement with new thru-hulls and seacocks. Boat hauled for survey.

32' sailboat needs new bottom paint and hull cleaning before launch. Currently on hard stand at yard.

Electric head not flushing properly. Macerator pump making grinding noise. Need full inspection and parts replacement.

28' Sea Ray needs full hull compounding, polishing, and wax application. Oxidation on topsides. Boat in water at slip.

Gelcoat gouge and small crack from docking incident. Approximately 18 inches long. Need gelcoat match and repair.

Prop has slight bend from hitting submerged object. Need removal, reconditioning, and reinstallation with new zincs.

Twin axle boat trailer. Bunk carpet worn through, bearings need repack. Need new bunk boards and bearing service.

Old VHF dead. Need new Standard Horizon radio and Shakespeare antenna installed at masthead. Mast stepped.

New chartplotter needs installation at helm. Transducer already in place. Need wiring, bracket, and system setup.

30' Catalina sailboat. Rigging is 12 years old. Need full inspection and likely replacement of shrouds and forestay.

Several gelcoat blisters on hull bottom. Need grinding, fairing, epoxy barrier coat, and new bottom paint. Boat hauled out.

Reverse cycle AC not cooling. Compressor runs but no cold air. Need recharge or compressor replacement.

Cabin, salon, and head need deep cleaning. Vinyl cushions, carpet, and galley. Boat at marina, owner offsite.

Old canvas torn and frame bent. Need new bimini top fabricated and installed. Custom frame work likely needed.

No power at the breaker panel. Shore power cord and inlet tested OK. Suspect internal wiring or transfer switch.

My 2021 Grady-White Freedom 235 needs a full exterior wax and polish. Oxidation on the bow and port side. Looking for someone who uses quality marine wax and can restore the gelcoat shine. No interior work needed. Boat is at a floating dock.